Stainless Steel Compressed Air Filter for Nitrogen Generator

Most industrial compressed air applications operate at pressure 7bar, 10bar or 13bar, and purification equipment is usually designed around these working pressures. However, some application require higher working pressure, which will also lead to an increase in the concentration of pollutants.
 
G-BHL series Stainless Steel Filter are designed to remove liquid aerosols, water, oil and sub-micron particles in the compressed air system. The Stainless Steel Compressed Air Filter efficiency can be 99.99% to remove 0.01 micron particles and small droplets, improve the pass rate of the product, reduce maintenance time and costs, increase productivity and reduce production costs ultimately.

The Stainless Steel 304 Air FilterTechnical Specification

The flow rate below is the treatment capacity of compressed air under rated working pressure 7 bar g (100psi g). For application in other working pressure, please refer to the correction factors.

Filter Element Performance

PF	AO	AA	AX	ACS	AR	AAR
As a primary filter, particles whose diameter more than 5μm can be removed, the maximum residual oil content is negligible.	High efficiency general protection, dust particles, water mist and oil mist whose diameter more than 1μm can be removed, the residual content of oil mist does not exceed 0.6mg/m³(21ºC), 1ppm(w).	High efficiency oil removal filtration, dust particles, water mist and oil mist whose diameter more than 0.01μm can be removed, the residual content of oil mist does not exceed 0.01mg/m³(21ºC), 0.01ppm(w).	Ultra-efficient filtration, dust particles, water mist and oil mist whose diameter more than 0.01μm can be removed, the residual content of oil mist does not exceed 0.001mg/m³(21ºC), 0.001ppm(w).	Dust particles whose diameter more than 0.01μm, oil vapor and odor can be removed, the maximum residual residual content of oil vapor does not exceed 0.003mg/m³(21ºC), 0.003ppm(w).	Dust particles whose diameter more than 1μm can be removed.	Dust particles whose diameter more than 0.01μm can be removed.