1200*400mm led Road construction solar arrow board

Main advantages and technical instructions of the 1200*400mm led Road construction solar arrow board:
1. The graphics use reflective film and LED + lens lamp beads, the brightness is much brighter than directly using LED lamp beads
2. Use solar power to convert light energy into electric energy, which is green and environmentally friendly
3. The box body is made of aluminum panels embedded and spliced, which is light and waterproof.
4. The installation method is simple and convenient. It can be installed on a folding bracket or on a pole with a back hoop.

1200*400mm led Road construction solar arrow board

The 1200*400mm led Road construction solar arrow board is composed of a box, a solar panel, two brackets, four red and blue flash modules and multiple C50 pixel tubes. The flash modules are composed of large lenses and have high brightness. The C50 pixel tube is our exclusive mold-opening shell. It has a unique shape and is composed of 6 LEDs. The LED lamp beads are covered with an exquisite lens plastic shell. The solar panel uses 15W/18V monocrystalline silicon, which has strong heat absorption and sufficient charging.
Uses of portable solar construction guide signs:

The 1200*400mm led Road construction solar arrow board is the construction arrow guide sign indicator, which is mainly used for various road construction instructions, engineering vehicles, municipal vehicles, garbage trucks, etc., to indicate that the vehicle is in operation or the road section is under construction, such as installing street lights, signal lights, Guide passing vehicles to pass safely and quickly. Or it can be used for road sections with potential safety hazards, such as curved roads, rain and fog road sections, and highways. With a controller to adjust the arrow direction, simple and convenient operation.

Installation of the 1200*400mm led Road construction solar arrow board hoop:
Bracket installation:

Drill symmetrically on both sides of the construction sign board to install two screws, tighten the screws, unfold the mounting bracket, and then place the sign board on the bracket. Or punch a hole on the bracket with the same distance from the screw on the side of the sign, and then fix it with a nut.

1200*400mm led Road construction solar arrow board bracket installation
When installing with a bracket, put two screws on each side of the guide plate to install the bracket. When installing, put the bracket on the screw on both sides of the guide plate, and then fix the bracket with a nut.

Wiring installation instructions for the 1200*400mm led Road construction solar arrow board:
The wiring of the solar panel and the sign board can be connected through the docking interface. Pay attention to the position of the concave and convex openings when connecting the interface, you need to align them, otherwise the positive and negative poles will be connected reversely, and the battery will not be charged. There are master switch and light control switch at the bottom of the sign.

It adopts switch button control, as shown in the figure above, the button is set at the bottom of the guide plate. The buttons from left to right in the figure are the main switch, the light control switch, the strobe switch, the left arrow switch, and the right arrow switch.

Application scenarios of the 1200*400mm led Road construction solar arrow board:

Traffic Safety Led Arrow Board

Engineering Vehicle Arrow Lamp
Vehicle Arrow Lamp
Vehicle Traffic Arrow Lamp