Unsaturated Polyester Resin Glue for Boat Building

Specifications 1.With the color of semi-transparent

2.With the mix ration of 200:1

3.Apply for the marine industry for bonding fiberglass

MTB-1026 Unsaturated Polyester Resin TDS     MTB-1026 Unsaturated polyester resin is two components glue, it is main used on the marine industry especially for bonding fiberglass.     Chemical Components  

Item	CAS NO.	Proportion (%)
Polymer		52-58
Styrene	10-42-5	42-48

      Physical and Chemical Character  

Item	MTB-1026 A	MTB-1026 B
Appearance	Semi-transparent	Semi-transparent
Mix ratio (By weight)	200	1
Odour	Pungent
Melting Point	-30.6℃
Boiling Point (℉)	145.2(styrene) ℃
Olfactory threshold	0.017 1.9 PPM (detection), and 0.15 PPM (aware)

      Package   It is 200kgs/drum.       Storage   1.   The tube is indoor or outdoor storage area, are not allowed to have fireworks or other source.
 
2. Far removed from antioxidant, corrosion, and other compatible material storage.
 
3.The storage area using grounding, use is not a spark of ventilation system, qualified explosion-proof device and safety of the electrical system, and consider adding leaking out detection alarm system.
 
4. Storage areas should be put up suitable warning signs, regularly check the leaking out or damaged, and device available agent near storage area and processing material spill.
5. Check all the storage container, established the proper labeling and without damage.
 
6. Keep container tightly and limited data storage.
 
7. Remove all hair fire and far removed from the heat and not compatible.
 
8. Not to air or inert gas pressure in the liquid from the container and carry out come.
 
9. If necessary, wear appropriate personal protective equipment to avoid contact with the chemicals or contaminated equipment.
 
10. Unless allocate area with bikes, fireproof structure or not will allocate work in storage areas.
 
11. According to the chemical manufacturer or supplier recommended storage temperature, storage, installation temperature detection alarm, when necessary to warn temperature is too high or too low.
12. Avoid large amount stored in indoor, store in turnover of fireproof construction as much as possible.
 
13. The exhaust pipe of storage tank shall be equipped with flame to prevent the device.  
          14. Storage tank must be for ground storage tank, the bottom of the whole area should                 be sealed with impervious attached documents, must have a containment around                    the entire capacity of the overflow dam.  
        15. Bikes, storage area should be done with general area partition and far removed from          the process the elevator or inward and outward.