for BMW Icom A2 Bc with Win 8 Icom Software Installed on Thinkpad X200t Full Set Ready to Use

It compare with ICOM XP Windows 8 version software can install Team Viewer, and also install printers yourselves. It runs much faster and stable than Windows 7 Version Software, its extremely fast start-up times.

What is the advantage of for BMW ICOM A2?
Due to the old for BMW ICOM A module has problem in the cooling and protection design, The new ICOM A2 adopts the whole aluminum shell body, using aerial explosion-proof connector; And it use the joint connection line which similar to the Mercedes-Benz COMPACT4 SDCONNECT.

For BMW ICOM A2+B+C Hardware description

For BMW ICOM A2+B+C is the a replacement of DIS GT1/SSS/OPS and OPPS.
ICOM A2-OBD style diagnostic vehicle connector with communication protocols for MOST, K-CAN, D-CAN, KL15/30 detection, ignition failure status, battery status and TD signal for measurements.

ICOM B-OBD style diagnostic vehicle connector with a high speed MOST extension for ICOM A2. Uses USB connection to the ICOM A2.

ICOM C-Old style 20 pin diagnostic vehicle connector (in engine compartment) to OBD. Service interval reset and engine speed signal.


Lenove ThinkPad X200T Configuration:

Model: Lenove ThinkPad X200T

CPU: Intel Core L9400

Memory: 4G

HDD: 500G



2014.11 for BMW ICOM RHEINGOLD Software with Expert Mode Multi Languages Installed on Windows 8
Top Reasons to upgrade your ICOM XP/Windows 7 software to Windows 8 Version:

1 compare with ICOM XP software
Windows 8 version can install Team Viewer, and also install printers yourselves


2 Windows 7 software VS Windows 8 software
Win 8 is 64 bit system, runs much faster and stable than Windows 7 Version Software, it support 64GB memory maximum.

3 Engineer Software Installed
4 Multi-Language Version
5 for BMW ETK Installed
6 Different from other websites, we offer you an all new 500GB HDD rather than an old 160GB HDD
7 Our ICOM Software installed on Windows 8 can works with for BMW ICOM and ICOM A2

8 Expert Mode supported, it is used for single module programming and coding.


Software version:
ISTA/D: 3.45.40
ISTA/P: 53.5.003
Not connected 9000 days remaining