2.Can you show how to use alarm wireless siren?                                              1.Plug off the power adaptor, connect WXJD slide switch
2.For 5800 alarm system: connect slide switch 26/23 to 23 (2 slide switches below)
3.Press the SENSOR key, the LED2 flashes, press 9 key of 5800hold it for 2 seconds, the alarm panel would transmit wireless code. The wireless siren would sound once after receiving the code.  Press SENSOR key to store this code and exit registering status.
5.when the alarm system alarms, the wireless siren would sound, and when the panel stops, it would also stop. 

3.How to use as control panel?                                                                         

1. Plug off the power adaptor, connect WXJD slide switch; after 2 seconds, plug in adaptor

2. Key fob registration: press the REMOTE key, and the LED1 flashes. Press a random key on the key fob to make it transmit a code. The siren would sound once after receiving the code. Press the same key of key fob for a few times more, the siren sound a beep every time. That means that is the correct code. Press REMOTE key to save it and exit reigistering status.

3. Wireless detector registration: press the SENSOR key, and the LED2 flashes. Press a random key on the key fob to make it transmit a code. The siren would sound once after receiving the code. Trigger the wireless detector a few times more, the siren sound a beep every time. That means that is the correct code. Press SENSOR key to save it and exit reigistering status.

4. Press the arm key of the keyfob, the red LED flashes slowly after 2 sounds di di. That means it is already armed. Press the disarm key of the keyfob. The red LED is on after a di sound and the siren is disarmed. Trigger the senor when the siren is armed status, the siren would sound for 72 seconds.

5. The siren can work with one wired detectors also. The wired detector should be NC. Plug in the one of the wired detectors signal wire to LINE and another to GND. When the detector is closed, the red LED on means the disarmed, and red LED flashing means armed. When the detector is open, the green LED on means the disarmed, and green LED flashing means armed.

6. registering the wired detector: press the SENSOR key, the red led2 key is flashing rapidly. Trigger the wired detector once(open circuit first then close circuirt) then close circuit the detector, when the green light is on. Arm the siren by remote. Trigger the wired detector, it alarms.